Problem by applying Config on Node behind Firewall #9047
Unanswered
53845714nF
asked this question in
Q&A
Replies: 2 comments 3 replies
-
Talos API runs over gRPC/TCP direct to the node on port 50000 in this case, so if something happens, it's within your network. It's either the firewall, or something else, like wrong MTU. Talos doesn't block any connections in the default (empty) configuration. You could use |
Beta Was this translation helpful? Give feedback.
0 replies
-
I get the right Output:
But the Problem with the applying config is still there. (for the recording, it is |
Beta Was this translation helpful? Give feedback.
3 replies
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
Hi, I have an Opensense Firewall before the Talos.
I try to apply the Config with this command:
./talosctl apply-config --insecure --nodes $CONTROL_PLANE_IP --file _out/controlplane.yaml
I get this:
I have the following Rule:
The allowed Ports are 50000 and 50001 als mentiond in: Talos Network Conectivity
The WAN network is my network in which my computer is located.
The firewall blocks noting:
My IP is: 192.168.178.181
The Cluster IP is: 10.2.0.10
I looked in to Wireshark, there are a lot of TCP retransmissions. But I don't know why.
wireshark.zip
Beta Was this translation helpful? Give feedback.
All reactions