BESC Spindle Feature
A lot of small CNC machines are using Brushless DC motors as the spindle motor. They are cheap and pack a ton of power in a small package. They are designed to be installed in RC vehicles and controlled with joysticks, so they take a little hacking to get them to work. Grbl_ESP32 can handle the basic electronic signals, but they vary greatly in features and setup requirements.
Bottom Line: This is an advanced feature. These motors/ESCs were not designed for this application. Each motor is different, so don't expect perfect support on the forums. The motor may not behave or be as responsive as a normal spindle motor. and...Never Trust It! Power it down when changing bits, etc
Brushless spindle motors are supported in Grbl_ESP32. These motors are controlled by an Electronic Speed Controller (ESC). They are primarily designed for RC planes, cars, drones, etc. ESCs have a similar control input to hobby servos. They use a PWM signal with pulses typically ranging from around 1ms (off) to 2ms (full speed), but you may need to adjust that.
Note: Often speed controllers have a battery eliminator circuit. Rather than requiring an input of 5V on one of the pins, they output 5V to power other low voltage electronics, that might be in the RC vehicle. You probably should not connect that to your CNC controller.
The ESC needs to learn what you want to use for your PWM max and PWM off values. You need to do a special turn on sequence for this to happen. On most ESCs, you only need to do this once for your settings. The ESC can use the coils to vibrate the motor to sound like beeps. These beeps will help you with the process.
Your BESC might be a little different, but a common startup sequence is a s follows. Set the PWM to max, apply power to the ESC, wait for some beeps, set PWM to minimum, wait for more beeps. There may be more steps to set other values. You need to do this manually via gcode commands when using the ESC feature of Grbl_ESP32. See more on this below.
I strongly suggest getting a servo tester. One with a knob and a digital readout is best. Make sure you can control your ESC with this before you try with Grbl_ESP32. It is much easier to learn the turn on sequence with the knob. I bought this one many years ago, it cost less than $10.
See this section of the spindles page
You need to supply supply power to you ECS. Be aware that ESCs can draw a lot of current. It also needs an easy way o turn it on and off.
The PWM signal is typically on a 3 pin connector. The PWM wire needs to go to the PWM output of the ESP32, per your cpu map.
You also need to connect the ground pin to a ground on your ESP32. You should not connect the 5V wire to anything.
Suppose your turn on sequence is...power on at full speed, wait for beeps, lower to minimum speed, wait for beeps. Also, your max RPM setting ($27) is 1000. Here is the gcode you would send
- S1000 M3 (sets RPM to 1000, PWM to Max, turns on spindle PWM)
- Power on the ESC
- Wait for beeps
- S0 (sets RPM to 0, PWM to min)
- Wait for beeps
- M5 (turns off spindle)
You can now control your spindle normally. For future uses, you probably don't need to re-calibrate, but you do nned to wait for the beeps that signal it is ready.